Ürünlerimiz
Герметики и заполнители швов \ Emülderz 2010 - Битумен резины на основе совместного наполнителя
Ürün Teknik Dökümanları |
| Tanımı | ||
| It is an elastomeric, hot-applied, bitumen-rubber based joint filler used at horizontal and vertical joints. | ||
| Usage Areas | ||
|
• It is used for waterproofing, filling, repair and adherence in: • Dilatations, joints, • Intersections of cement coatings with wide surfaces, • Dams, channels and ducts, • And other locations where any dilatation may occur. • It is used for installing reflective road buttons onto asphalt. |
||
|
||
| Surface Preparation | ||
|
• The surface to be treated must be clean and dry. • The joints must be cleaned with a wire brush, spiral engine or sandblasting. • If possible joint spacing must be treated with compressed air. |
||
| Application | ||
|
• To provide excellent adherence, and improve durability, non-metallic surfaces can be undercoated with Emilkote®, and metallic surfaces can be undercoated with Emülzer® C. • Emülderz® is heated up to approximately 160-180°C, mixed thoroughly and poured into joint gaps. • The surface treated will be ready to use after approximately 1 hour. • If the product is overheated, that is up to temperatures over 160-180°C or if it is heated up and cooled back for a few times it will be spoiled and cannot be recovered. |
||
| Consumption | ||
|
1,17 kg/dm3 Example: For joints with 1 meters lenght 5 cm width and 3 cm depth 1 m x 0,05 m x 0,03 m x 1,17 kg/dm 3 x 1000 = 1,755 kg of product used. |
||
| Packaging | ||
|
17 kg Metallic case - 45 Pieces / Pallet Bulk in easy-to-separate cardboard box |
||
Ürün Teknik Dökümanları |
